Thanks to the JOG1, the submarine is able to dive both vertically (statically) and at speed (dynamically) using diving planes. The sensitive diving system allows you to adjust submarines weight preciselly, so you can cruise at periscope depth or sit on the bottom of your "sea". The speed of diving and surfacing could be regulated as well. The system has fail-safe built in, so when the signal is lost the submarine surfaces on it's own.

This system is suitable for both beginners and advanced modellers. Particullar parts are glued into the submarine's hull. They are supplied as finished assemblies.

RC system is separated into 3 sections. Motor compartment has it's own case and sealing. RC equipment (3 servos, regulator, fail-safe system) is built into shaped Plexi tube, which is connected to a ballast tank. Batteries has their own case with sealing as well.

Equipment:

Propulsion Unit:

2x Motor 3V, 2x stainless steel shaft, motor tang, shaft lead off, shaft friction bearings, 2x counter-running propellers, switch.

Linkages:

Front diving planes axes, back (rudder & diving planes) axes, friction bearings for axes, lingages, ball pivots, bowden cable, lever mechanisms, hinges.

Watter Tight Compartments:

Batteries casing (reaktoplast), RC equipent specially shaped casing (transparent plexi), tube lead, front and back caps for the casing, servos holder, ballast tank assembly, motor compartment casing (3 pieces), motor compartment cover, screws.

Pressure Tank:

Pressure tank assembly, inlet vent, pressure tank reduction, trigger mechanism, outlet vent assembly, filling vent.

 

NOT included:

2x servo (Naro 3710 or Hi-tec HS-55), two way regulator i.e. Dsys MD10DCR 10 A, 5x 1,2V NiCd batery, reciever i.e. Jeti Rex 4, 4 channels, Fail Safe circuit.

Drawings & Documentation:

Assembly & Installation Manual (2D and 3D pictures, 50 pages; please note, that some material sare currently available in Czech language only). Drawings (elevations, sections, schemes, jigs)